McIntosh · Turntables
McIntosh turntables: the MT2, MT5 and MT10
McIntosh makes three turntables, each supplied with its tonearm and cartridge fitted and aligned at the factory, and each built to sit in a McIntosh system.
The idea
McIntosh was founded in 1949 and did not make a turntable for nearly sixty years. When it did, with the MT10, it set the pattern for the three that followed: a turntable that arrives set up, so that tracking force, anti-skate and cartridge position are done before it leaves the factory, and one that looks and behaves like the rest of a McIntosh system.
McIntosh and Clearaudio worked together to build them. The platter that floats on a magnetic bearing in the MT5 and MT10 is an idea the two share. Three ways to build a turntable sets out where that idea sits among the others.
MT2 Precision Turntable
The MT2 arrived in 2018 as the third McIntosh turntable and the least costly. It plays 33⅓ and 45 rpm. The outer platter is black polyoxymethylene more than an inch thick, dynamically balanced, on an inner platter of machined aluminum, and a soft green glow comes from beneath it and from the edges of the plinth.
The tonearm has a dural-aluminum tube, with ceramic vertical bearings and a gimballed sapphire bearing for horizontal movement. It is supplied with a Sumiko Moonstone moving-magnet cartridge and a dust cover.
Ask us about the MT2: call (503) 222-2599 or email sales@pearlaudio.com.
MT5 Precision Turntable
The MT5 is the turntable most people picture when they think of McIntosh. A platter of silicon acrylic, lit green from below, floats on a magnetically suspended ceramic bearing above a black glass plinth. Opposed magnets carry most of the platter's weight, so the bearing surfaces carry almost none.
It plays 33⅓, 45 and 78 rpm under servo control. The tonearm is a dural-aluminum tube on magnetic sapphire and ceramic bearings, with magnetic anti-skate, and the cartridge is the Sumiko Amethyst moving magnet.
MT10 Precision Turntable
The MT10 was McIntosh's first turntable and is still its flagship. It adds a brushless motor with electronic braking, and an illuminated meter that shows platter speed in the style of McIntosh's power meters. The platter is silicon acrylic on a magnetically suspended ceramic bearing.
The cartridge is McIntosh's own low-output moving coil, with an ebony body, producing 0.5 mV. John Loranger was at the show where McIntosh first unveiled the MT10, and photographed it there.
The phono stage
The MT2 and MT5 carry moving-magnet cartridges, which suit the moving-magnet phono input on a McIntosh preamplifier or integrated amplifier. The MT10's moving coil needs a moving-coil input, and McIntosh recommends a load of 400 to 500 Ω for it.
McIntosh's MP100 phono preamplifier has both inputs. On its moving-coil input, at 60 dB, the MT10's 0.5 mV becomes 500 mV, in the middle of the gold band, and the MP100 has a 400 Ω setting. The MP100 and the cartridges that suit it.
MTI100 Integrated Turntable
The MTI100 takes a different route. It is a belt-drive turntable with a vacuum tube preamplifier, a phono stage and an amplifier built in, and a Sumiko Olympia cartridge fitted. Add a pair of loudspeakers and it is a complete system.
Read about the MTI100 → McIntosh analog →
Sources: McIntosh's published specifications and its 2018 announcement of the MT2; SoundStage! Ultra's review of the MT10.



