Analog at Pearl Audio
Which cartridge suits which arm is the question we are asked most about record players. Two short sums answer most of it: whether the arm and cartridge suit each other mechanically, and how much gain the phono stage must supply.
Step one
A tonearm has weight, and the stylus sits on a small spring. Together they resonate at one low frequency. If that frequency falls between about 8 and 12 Hz it sits safely below the music and above the slow movement of record warps, and the pairing will track well. Too low and warps and footsteps disturb the stylus. Too high and the bass thickens.
Enter the figures from the two makers' specifications. A heavier arm wants a stiffer cartridge, and a lighter arm wants a more compliant one.
Step two
Cartridges differ widely in how large a signal they produce. A phono stage with too little gain sounds quiet and noisy, and one with too much can overload on loud passages. Enter the output the maker quotes, in millivolts, and we will show the range to look for.
For a moving coil, the stage's input load matters too. Begin with the load the maker recommends. Where none is given, a common starting point is no less than ten times the cartridge's own coil impedance.
What the numbers leave out
These sums are a guide. Makers measure compliance in different ways, arms differ in how they are damped, and two pairings with the same figure can behave differently on a real record. When we fit a cartridge it is aligned on the arm it will play on, so the match is confirmed, not assumed.
If you would sooner not look up the figures, tell us your turntable, your arm and the cartridges you are considering, and we will answer with two or three that suit.