Computer Audio Design's Ground Controls treat the part of a system most designers leave alone: the signal ground. CAD describes the negative side of every RCA, XLR, USB and Ethernet connection as a path that carries high-frequency noise from switching supplies, processors and radio sources, and a Ground Control connects to those grounds through dedicated cables. Inside is a combination of proprietary materials that CAD says converts energy from about 1 MHz up into the GHz range into heat. The unit is entirely passive and never plugs into the wall.
The GC3.1 replaced the GC3 in 2022 with revised internal materials that CAD says cover a broader frequency range and attenuate more noise. With six 4 mm sockets and more than three times the mass of the GC1.1, it is sized to take a streamer, DAC, phono stage and preamplifier at once, with sockets to spare for the mains earth or an amplifier chassis. CAD says the GC3.1 and GC-R work exceptionally well connected to the mains earth and directly to the cases of the amplification as well as to unused inputs on the sources.
Isabel Whitley of CAD reports that the GC3.1 is bought most often by dCS owners, usually alongside the Ethernet Control and USB Control, and Pearl Audio's experience with dCS and Linn front ends matches that. In our large listening room a GC3 has treated all of the front-end electronics while a GC1 looked after the power amplifiers between the speakers. The Ground Control range was Stereophile's 2020 Product of the Year in the accessory category.